Complete shaft set for rear fork for Yamaha DT50 with axle, bushings, spacer tube, protective rubber for swing, washer & nut.
Shaft specification:
Length: 195mm
Thread: M10x1.25
Surface treatment: Galvanized
Note
As different manufacturers/brands specify length measured in different ways, we would like to point out that length specifications for NTS axles/screws/bolts are always specified in effective length, i.e. NOT total length.
Shaft specification:
Length: 195mm
Thread: M10x1.25
Surface treatment: Galvanized
Note
As different manufacturers/brands specify length measured in different ways, we would like to point out that length specifications for NTS axles/screws/bolts are always specified in effective length, i.e. NOT total length.
The protective rubber is not a sliding plate for the chain, but only intended to protect the swing fork from damage in the event of too slack a chain and should therefore not be used for raised mopeds.
